Create by students ‚work for the world. Check our story.

D6 & GR2 FAQ

1.How to insert the D6 data cable into the extruder?

2. How to tighten the locking bolt between the driving system and nozzle?

3. How to eliminate the Aka sound from the X and Y axis bearing bracket?

4. How does a Wanhao Duplicator 6 working and printing a rhino?

5.How to add Wanhao Duplicator 6 rubber feet?

6.How to clean the jam of WANHAO D6 MK11 extruder?

7.How to disassemble the MK11 extruder?

8.How to fix the D6 heating board keeps heating without stop?

9.How to fix D6 heating board thermistor broken?

10.How to fix D6 warning message" error stopped, tem sensor"?

10.How to fix D6 warning message" error stopped, Z switch broken"?

11.How to replace the side flat bearing of D6?

12.How to dis-assemble the D6 platform?

13. How to assemble the D6 platform?

14.How to reconnect the D6 OLED display yellow data cable?

15.What is review of D6 from third party?

16.How to eliminate the strings by adjusting the retraction?

17.How to make perfect first layer?

18.How to fix the filament break inside extruder(amount block)?

19.How to by pass the relay on the D6 motherboard?

20.Duplicator 6 review

21.How to use D6 auto bed leveling and manual leveling?

22.How to replace blue ABL sensor to the orange one?

Instruction

23.How to fix D6 extruder wobbling?

24. How to Replace D6 splitter board(inter-board)?

25. How to fix the Heater Error issue?

26.How to install the D6/ plus ribbon cable?

27.D6 EMotor Troubleshooting

28.D6 Reading Card

29.Replacing D6 Plus HotEnd

30.How to test the sensor function of D6plus inductive sensor?

31.How to fix the X axis end stop switch not working?

32.How to fix the shifting issue of D6?

33.How to do D6plus auto leveling?

34.How to Change D6 plus Mk2(auto leveling) to Manual leveling?

35.How to fine tune the leveling of D6 plus?

36.Marlin for Gr2

Gr2 Marlin

37.Extruder Protector for D6(16 pin) and D6/plus(20 pin).

For D6 For D6plus

38.Filament holder for D6/plus/Gr2